HANKO MACHINE WORKS
~ Direct from the Maker from Blade Show 2019 ~
This one is a Full Zirconium Twisted Trident ~ Crafted from a Single Piece of Solid Zirconium with a Wide, Matching Custom Titanium Clip by Steel Flame
This light has amazing Custom Fit and Finish ~ Very Rugged and Hefty due to the Materials. Solid C110 Copper Heat Sink for the greatest Thermal Mass.
Thick Rubber McClicky Selector Switch. *To Switch Modes ~ see instructions below.
Triple Neutral tint 5000K Driver – Cree XP-G2 LED’s with the brightest available S3 BIN. Recessed Watch Crustal Lens
This is the actual light that you will receive.
Uses 18350 Batteries ~ Not CR123.
I have only ONE
To switch mode groups:
Rapidly tap the switch 8 times, holding the last tap. The light will then enter the programming mode and begin to flash. With the light in programming mode, tap the switch the same number of times as your desired mode group. The light will blink and your mode group will be memorized.
Example: To select mode group 3, tap the switch 8 times quickly to enter programming mode. As soon as the light enters programming mode and starts flashing, tap the switch three times (for group 3). The light will blink to recognize the mode group change.
To set the Turbo Timer:
Rapidly tap the switch 8 times, the light will then enter the programming mode and begin to flash. With the light in programming mode, tap the switch 30 times to enter the turbo timer set mode. The light will then switch to 100% power. When the light is at the desired temperature for the turbo step down, turn the light off. The turbo timer will then be set. Turbo timer drops down to 50% output.